3rd Shift Lamination Operator

Littleton, CO

Job status
Full time
Job description
Anaren is now hiring a Lamination Operator to work 3rd shift.

As the Lamination Operator you will lay up I/L cores with pre-preg and copper foil, utilizing heat and pressure the booked I/L cores are pressed to form a panel.

Under close to minimum supervision, and depending on assigned job level and skill capability, the Laminator will be able to process panels through the lamination operation per the designated Manufacturing Process Procedures.

Lamination skills you will be utilizing are:
• Flash route
• Breakdown
• Lay up
• Material preparation
• Lamination press.

This is a drug-free facility. You must be able to pass a drug test.
Experience requirements
• Previous PCB experience preferred
• Previous PCB lamination experience highly desired
Qualifications
• Must be eligible to work on defense and satellite programs subject to ITAR Regulations. Therefore, candidates must be a U.S. Citizen or a U.S. Permanent Resident ('Green Card').
Ability to understand and follow daily work direction and process instructions from supervisor or other qualified person in English.
• Ability to understand and follow posted procedures.
• Ability to understand and follow all safety codes.
• Ability to communicate fluently in English, including basic reading and writing.
• Ability to pay attention to directions and focus on details.
• Must comply with TTM Export Control Policies and Procedures and all applicable laws including ITAR, EAR and OFAC including but not limited to:
a) being able to identify ITAR product on the manufacturing floor and understand that access to these products and related technical data is restricted to only US Citizens and US Permanent Residents
b) recognition of Foreign Person visitors by badge differentiation.
Responsibilities
• Monitor humidity in material prep room.
• Verify requirements of incoming materials to package label. (Vendor, correct material, lot number, proper marking, thickness, size)
• Monitor accuracy of material inventory.
• Monitor usage of material by shelf life.
• Cut Pre-preg, caps, copper foil, and Tedlar as required.
• Drill lay up holes as necessary.
• Verify that all necessary materials are available prior to start of job lay-up.
• Lay-up panels per lay-up sheet and traveler.
• Verify bake cycle of details prior to lay-up.
• Clean caul plates with Time Saver.
• Monitor to insure uniform and constant flow of work through area.
• Verify humidity of lay-up room.
• Measure thickness of finished panels.
• De-pin and breakdown books.
• Clean resin from tooling holes, move to flash route for route after lamination.
• Measure panel thickness using micrometer.
• Brush panels for particles.
• Verify press calibration.
• Verify proper vacuum pressure of press.
• Assure proper placement of books in press.
• Verify temperature and cycle time per traveler.
• Monitor to insure uniform and consistent flow of work through presses.
Skills
• Must be able to regularly lift 50 pounds and carry materials.
• Must be able to stand for 8-10 hour shift.

About us:
In 2017, Anaren celebrated its 50th year in manufacturing and in May 2018 was acquired by TTM Technologies. This acquisition combines TTM’s strength in PCB manufacturing with Anaren’s radio frequency (“RF”) design capability and a product portfolio of unique and proprietary RF components and subsystems for the Aerospace & Defense and Networking/Communication end markets. The combined company will be strongly positioned to benefit from the expected increase in spending for advanced radar technology in the Aerospace & Defense market and 5G technology in the wireless infrastructure market.

All qualified applicants will receive consideration for employment without regard to race, color, religion, sex, sexual orientation, gender identity, national origin, citizenship, disability or protected veteran status.
Work hours
Monday- Friday 11:00pm-7:30 am.
4972

OR

Apply